Aliens Pulse Rifle
Links To
Latest
Pages
Space Giraffe
London Jolly
Ashdown For. Llama Park
These pages show the assembly of the PR kit on the Thompson parts.
Note: When I neared completion of the PR, I found I had three bolts of the wrong type,
so somewhere on these pages I show hex head bolts,
when they should be Phillips head bolts. :-/
When I find out which ones, I'll amend the page(s). So take care when assembling the PR!
If you know which ones are wrong, please contact me via the link at the bottom of this page.
There are two sets of images. One set is fairly small file sizes (135KB) for easy viewing.
The other set are large (1.4MB) high resolution images, suitable for printing to A4 size.
Click
on thumbnails to open full images in a new window
| SMALL | LARGE | |
| The joint block has to sit inside like this: to allow the two sections to fit |
) |
) |
| Put the locking pin back in place and slide/push the two halves together |
) |
) |
| Make sure the wires aren't caught up inside, so they're long enough for later on. |
) |
) |
| These are the parts for the stock |
) |
) |
| The smaller block fits very tightly inside, needing a tap or two to fit |
) |
) |
| A little WD-40 or such may help |
) |
) |
|
These two bolts
|
) |
) |
) |
) |
|
| Stock end piece finished. |
) |
) |
|
Position the stock |
) |
) |
| Then tighten the four bolts, using a 2mm hex key. |
) |
) |
| Lubricate the stock slider and check it moves freely. |
) |
) |
| Plug a 9v battery and use on/off switch to check the counter display |
) |
) |
| It should read 0 from start |
) |
) |
) |
) |
|
| and 95 when the button/lever inside is pressed. |
) |
) |
Contact
webmaster
Copyright (c) 2007 Stephen Charles Morton. All rights reserved.
Links To
Popular Pages
Llamasoft Games
Sheep Games
Events/Jollies